Entering And Leaving The Network; Batteries; Troubleshooting - Faq - Adeunis RF Vokkero BasiX Instrucciones Para El Uso

Ocultar thumbs Ver también para Vokkero BasiX:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

2.4. Entering and leaving the network

When the communication network has been created, each time your terminal enters or
leaves the network, this is indicated by two beeps:
* 4 rapid beeps -> entering the network
* 2 slow beeps -> leaving the network
3.

Batteries

The following batteries are proposed with the Vokkero terminal:
ARF7668 DT :
Audio conference system with a 3.7 V 2260 mA/h battery
Operating temperatures:
It is possible to recharge the battery before it runs totally fl at.
Subject to normal temperature and operating conditions, the charge time is 5 to 6 hours for a
2260mAh battery that is completely fl at.
The battery life is approximately 12 hours.
IMPORTANT NOTE: When the device is switched off, the battery will run fl at due to low-
level power consumption whilst in the Off position. It is recommended that you remove the
battery from the device when it is not being used and that you check the battery charge level
before using it again.
Only use the Easy pack batteries for which the references are provided in these instructions,
and which are supplied by Adeunis RF. Using unsuitable batteries or chargers may give rise
to risks of fi res, explosions, leaks, or other damage.
IMPORTANT NOTE: The user must recycle his or her used batteries by dropping them off at
a battery collection point.
To fi nd a collection site near you:
In Switzerland, Appendix 4.10 of SR 814.013 applies for batteries.
4.
Troubleshooting – FAQ
Frequently encountered problems are presented below in order to help you solve them.
I am unable to communicate with other devices.
Make sure that one of the devices has the number 1 as its ID.
The device is unable to connect to a conference.
Do not assign the same number to several devices.
The device will not switch on.
Check that the battery is charged and has been properly inserted.
Communication is being jammed.
Make sure that there is no contact between the antenna and the earphones cable.
Make sure that all the terminals are identifi ed using different numbers.
I hear crackling.
The microphone in one of the devices is probably damaged. Replace it.
I can hear myself speaking – there is an echo.
Check that the microphones in the various devices have a minimum distance of 10
metres between them.
The keys are not working properly.
Make sure that your fi nger is pressing the concave part of the key (where the symbol
is).
Do not press more than one key at a time with your fi nger or hand.
208445A-V1-UG-VOKKERO BASIX
-10 to +50°C
http://www.call2recycle.org/
GB
12
Tabla de contenido
loading

Tabla de contenido