Idiomas disponibles
Idiomas disponibles
Carefully remove the product and any accessories from
the box. Make sure that all items listed in the packing
list are included. Inspect the product carefully to make
sure no breakage or damage occurred during shipping.
Do not discard the packing material until you have
carefully inspected and satisfactorily operated the
product. If any parts are damaged or missing, please
call 1-800-261-3981 for assistance.
Do not use this product if any parts on the packing
list are already assembled to your product when you
unpack it. Parts on this list are not assembled to the
product by the manufacturer and require customer
installation. Use of a product that may have been
improperly assembled could result in serious personal
injury.
1
Operator's manual
1
Cutting blade protective cover
1
Spark plug wrench
1
60ml bottle of oil
To prevent an accidental start that could cause serious
personal injury, always disconnect the engine spark
plug wire from the spark plug when assembling parts.
Never install, remove, or adjust any attachments while
power head is running. Failure to stop the engine can
cause serious personal injury.
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a
Always wear eye protection with side shields marked to
comply with ANSI Z87.1, along with hearing protection.
Failure to do so could result in objects being thrown into
your eyes and other possible serious injuries.
If any part of the unit is missing or damaged, do not
operate the unit until the damaged part is repaired
or replaced.
WWW.SENIXTOOLS.COM
discard box or packing material until all parts
are examined.
Attempting to start the engine before it has been
failure not covered by the warranty.
MAX
performance and service life.
Always use a 4-cycle engine lubricant that meets or
SJ. SAE 30, 10W30, or 10W40 are all acceptable
lubricants to use in this product. Non- detergent or
2-stroke engine lubricants will damage the engine and
should not be used. Check lubricant level before each
use.
1. Unscrew the oil cap from the engine and remove.
tighten the oil cap.
2. Unscrew the oil cap and remove.
hole (the top of screw thread).
5. Replace and tighten the oil cap.
excessive smoke, oil loss, and engine damage.
Operation of this equipment could create sparks that
may be required. The operator should contact local
prevention requirements.
7
