Black+Decker BD-18-DWH Manual Del Usuario página 17

Water is Voltage less than 240
heated, Volts
but not hot
enough.
Water is too The water flow rate
hot. through the heater is
too slow.
Temperature setting is
too high
Water Temperature at
faucet is too hot.
Heater Power outage or
shuts off faulty wiring.
during use.
Water stops Possible Blockage in
flowing. water pipes or hoses.
Water Water pressure has
temperature dropped below a
varies from minimum level.
hot to cold
during use.
The computer chips in your tankless water heater are
programmed with the expectation that your incoming line
voltage is 240 volts. If you have less than 240 volts [i.e.
208V or 220V], it may affect the reading on your water
heater's digital display and cause it to read slightly higher
than the actual output temperature. To compensate
for this, increase the setting on your water heater if you
need or want hotter water.
Increase the flow rate at the water outlet.
Switch to a lower temperature setting.
Check for too little flow, or if the set point temperature is
too high. This could possibly indicate a possible internal
part failure. Call us for technical assistance.
Check the power supply. Check the circuit breakers.
If the problem persists, please call us for further technical
assistance.
Make sure the main water line valve is fully open, and
there are no obstructions in the water supply line.
Increase the flow rate from the water supply source.
17