Black+Decker BD-18-DWH Manual Del Usuario página 15

Starting the system for the first time
1. Press button, to activate the heater to display outlet temperature.
2. With the water running through the unit, press
Freezing Temperatures
If the ambient temperature falls below 32°F (0°C), protect the heater from potential damage. Power
off the unit using the dedicated circuit breaker on the main electrical panel. Open a faucet slightly
to cause water to flow continuously through the device at a very low rate, without heating. Restore
power to the unit when temperature condition is normal.
If the water inside the heater freezes, it can cause damage that is not covered by warranty. If
you suspect water has frozen within the unit, do not turn it on until you are sure the frozen water
has melted, and there are no leaks in the unit. It is recommended to contact a qualified electrician
or the manufacturer for service in this situation.
or
118 F
º
temp
to adjust the temperature.
Digital temperature display
Temperature setting Buttons
Power Button
Cold water inlet
Hot water outlet
(to be connected to the main hot water pipe)
15