Tabla de contenido
Enlaces rápidos
© 2009-2010, Moog Videolarm, Inc. All Rights Reserved
R H W 7 C N - 3
SView™ Vandal-Resistant Rugged (Outdoor Dome Housing)
Installation and Operation Instructions for the following models:
RHW7CN-3
7" Vandal-Resistant Outdoor dome housing with wall mount, rugged cast aluminum top and
polycarbonate clear dome, with 24VAC input, heater/blower, with a SView™ network pan/tilt.
RHP7CN-3
7" Vandal-Resistant Outdoor dome housing with pendent style, rugged cast aluminum top and
polycarbonate clear dome, with 24VAC input, heater/blower, with a SView™ network pan/tilt.
RHW7CS-3
7" Vandal-Resistant Outdoor dome housing with wall mount, rugged cast aluminum top and
polycarbonate clear dome, with 24VAC input, heater/blower, with a SView™ analog pan/tilt.
RHP7CS-3
7" Vandal-Resistant Outdoor dome housing with pendent style, rugged cast aluminum top and
polycarbonate clear dome, with 24VAC input, heater/blower, with a SView™ analog pan/tilt.
Before attempting to connect or operate this product, please read these
instructions completely. To be used with the 81-IN5409 Instruction Manual.
www.videolarm.com
CERTIFIED
81-IN5378
10-18-2010
Tabla de contenido
Manuales relacionados para Moog Videolarm RHW7CN-3
Resumen de contenidos para Moog Videolarm RHW7CN-3
- Página 1 © 2009-2010, Moog Videolarm, Inc. All Rights Reserved R H W 7 C N - 3 SView™ Vandal-Resistant Rugged (Outdoor Dome Housing) www.videolarm.com Installation and Operation Instructions for the following models: RHW7CN-3 7” Vandal-Resistant Outdoor dome housing with wall mount, rugged cast aluminum top and polycarbonate clear dome, with 24VAC input, heater/blower, with a SView™...
- Página 3 LIMITED WARRANTY FOR VIDEOLARM INC. PRODUCTS VIDEOLARM INC. warrants this Product to be free from defects in material or workmanship,as follows: PRODUCTCATEGORY PARTS LABOR All Enclosuresand Electronics Five (5) Years Five (5) Years Pan/Tilts Three (3) Years **6 months if used in autoscan Three (3) Years **6 months if used in autoscan /tour operation /tour operation...
-
Página 4: Electrical Specifications
Contents of Box Electrical Specifications RHW7CN-3 RHW7CS-3 RHP7CN-3 RHP7CS-3 Power 24VAC Class 2 Only 24 VAC 80 Watts Accessories: Heater: 50 Watts, Blower: 2 Watt Camera Power: (See Camera Specifications): 28 Watts Max Tools Required: .100” Flat Head Screwdriver Phillips Head Screwdriver... - Página 5 WALL MOUNTING 4”-5” Trim incoming control & power wires to 4”- 5”, Bracket is designed for 45° conduit tting (If using the for either wall or pendent bracket conduit). Run wire into bracket secure to wall. • El soporte se diseña para la guarnición del conducto 45° (si usa el •...
- Página 6 WALL MOUNTING Important Gasket Must be in place 28 Watts 52 Watts COAX (coax wire not supplied) Wiring the dome can be completed by Align large arrows referring to the diagram. • Atar con alambre la bóveda puede ser terminada •...
- Página 7 FOR PENDENT/ WALL MOUNTING 4”-5” Trim incoming control and power wires to 4-5 for Secure lanyard to lanyard clip either wall or pendent bracket • La tapa segura de la cubierta SM5 con mercancías duras • Con seguridad soporte del montaje a emparedar. Tire del cableado a través del soporte y del ojal de la posición según lo demostrado.
- Página 8 Important Gasket Must be in place Align large arrows To lock turn clockwise • Alinee las flechas grandes • Alinee las flechas grandes • Alignez les grandes flèches • Alignez les grandes flèches • Richten Sie große Pfeile aus • Richten Sie große Pfeile aus •...
- Página 9 RJ45 24VAC POWER Camera Max 28 Watts Camera Orange Heater/Blower Yellow 52 Watts Heater/Blower Green (Outdoor Only) Alarm 1 Blue Alarm 2 Violet Alarm 3 Gray Common White Make the appropriate male and female connections. • Haga las conexiones masculinas y femeninas apropiadas. •...
- Página 10 Remove Pan/Tilt from shipping carton. Align the arrows on the outside of the dome Install in base bracket in housing. and lock. • Alinee las flechas en el exterior de la bóveda y • Quite Pan/Tilt del cartón del envío. Instale en soporte trábese.
- Página 11 PB24 Addendum Additional wires are provided to run power to PB24. Use with connector supplied. Run RJ45 connector through PB24, wall mount, and connect lead from housing. • Los alambres adicionales se proporcionan a la energía funcionada con a PB24. El uso con el conectador proveyó. Funcione con el conectador RJ45 con PB24, emparede el montaje, y conecte el plomo de la cubierta.
-
Página 12: Replacement Parts List
Replacement Parts List RHW75 IRHW75 PART NUMBER DESCRIPTION RC7C CLEAR REPLACEMENT CAPSULE 1A RC7T TINTED REPLACEMENT CAPSULE RPRH752 LOWER TRIM RING RPRH7503 DOME CLAMPING RING RPNET02 NETWORK HGS POWER SUPPLY RPFD072 24V HEATER 5A RPFD072/12 12V HEATER (12VDC MODELS ONLY) RPFD080 BLOWER RP40PCMD01... -
Página 13: Product Registration/Warranty
Product Registration/Warranty Thank you for choosing Videolarm. We value your patronage and are solely committed to providing you with only the highest quality products available with unmatched customer service levels that are second-to-none in the security industry. Should a problem arise, rest assure that Videolarm stands behind its products by offering some of the most impressive warranty plans available: 3 Years on all Housings, Poles, Power Supplies, and Accessories and 5 Years on all camera systems (SView, QView, Warriors), and InfraRed Illuminators.