Raychem E-100-L Instrucciones De Instalación página 6

6
E-100-L Installation Instructions
12
• Fasten end seal stand to pipe with pipe strap.
Do not pinch heating cable. Be sure pipe strap
is under heating cable.
• Loop and tape extra heating cable to pipe.
Minimum bend radius is 3/4 in (20 mm).
13
• Place blue crimps
onto bus wires.
14
• Push excess wire
inside light.
Insulated
parallel
crimps
Be sure wires
are not caught
in threads.
Note: For 1 in (25-mm)
and smaller pipes use
adapter (purchased
separately) between
stand and pipe.
JBS-SPA
adapter for
small pipes
• Crimp bus wires to
• Tighten light onto end seal stand.
Position
adapter this
side up.
lead wires.