Raychem E-100-L Instrucciones De Instalación página 5

6
• Mark the jacket
as shown.
8
• Push core sealer onto the heating
cable to the mark made in step 6.
Note: Extra force may be required for
larger cables or at lower temperatures.
Make sure the bus
wires do not kink,
bunch, or crossover.
10
• Pull cable back through end seal
stand until braid is just visible above
strain relief.
1 3/4"
(44 mm)
Braid
5/8"
(15 mm)
Strain
relief
7
CAUTION: Health Hazard.
Wash hands after contact with sealant. Consult material
safety data sheet VEN0033.
• If needed, re-twist and straighten bus wires,
then insert bus wires into guide tubes as shown.
Make sure all strands
go into the tubes.
9
• Remove the guide tubes and dispose
of them in a plastic bag.
11
• Trim exposed conductors.
1/2"
(13 mm)
E-100-L Installation Instructions
Tubes
5