REAR LIGHT »RL-MINI CLIP/ MRL-MINI«
Technische Daten und Hinweise
With 3 LEDs standlight via capacitor
u
Tested and approved in accordance with the
u
German Road Traffic Licensing Regulations
(StVZO)
The reflector surface of the taillight must be
u
oriented vertically to the road and at a right
angle to the longitudinal axis of the road.
Nominal performance: 0,6 W
u
Input voltage: 6V AC
u
PLEASE NOTE
If an LED fails, the entire light unit must
be replaced!
Connecting the rear-light (Clip):
Rearlight cable +
(black)
Rearlight cable –
(black+white)
2
Screw for
adjustment
Mounting is only permitted on bicycles with mudguards that provide a sufficiently tight fit. A tight fit is normally given if the
normal position does not change after mounting when a force of 2N is applied and a torque of 1 Nm is applied around the
vertical axis. After a continuous load of 5 hours with 200 N has been applied, it must be ensured that the luminaire automati-
cally returns to the prescribed normal position.
Before each ride, make sure the rear light is securely mounted and not obscured.
Important:
Rear-light and headlamp must only be switched
on at the same time in case they are run by one
alternator.
This rear-light should only be connected to a
frontlight with separate on and off technology.
Atachment of the rear-light:
Mounting hight: 250-1200 mm
u
Pass the cable through the hole in the
u
mudguard (Fig. 2).
Fasten the rear light to the mudguard using the clip/
u
screw provided.
CLIP: To do this, push the clip through the recess
u
Input
and fasten it to the mudguard stay by snapping it
Recess::
into place (Fig. 3).
Only permitted on bicycles with mudguards
2 mm
6 mm
that already have a recess as shown in Fig. 1 as
standard.
14 mm
To adjust the rear light, turn the light to the
u
correct position.
Before each ride, make sure that the light is
u
13 mm
firmly mounted and that the rear light cannot be
The material thickness
adjusted unintentionally.
of the mudguard at the
recess is 1.2 mm.
1
Clip
3
reference axis runs parallel to the
road and parallel to the vehicles
longitudinal axis
Input:
AC 6V
Screw
GB