Dell PowerConnect 6200 Serie Guía De Introducción página 40

L'exemple suivant montre la séquence d'invites et de réponses d'une session exemple de l'assistant
Easy Setup de Dell. Les valeurs utilisées sont celles qui sont indiquées ci-dessus.
Au démarrage du commutateur (après le POST), la boîte de dialogue suivante s'affiche :
Welcome to Dell Easy Setup Wizard
The setup wizard guides you through the initial switch
configuration, and gets you up and running as quickly as possible.
You can skip the setup wizard, and enter CLI mode to manually
configure the switch. You must respond to the next question to run
the setup wizard within 60 seconds, otherwise the system will
continue with normal operation using the default system
configuration. Note: You can exit the setup wizard at any point
by entering [ctrl+z].
Would you like to run the setup wizard (you must answer this
question within 60 seconds)? [Y/N] y<Entrée>
Étape 1:
The system is not configured for SNMP management by default. To
manage the switch using SNMP (required for Dell Open Manage Network
Manager) you can:
o Set up the initial SNMP version 1 & 2 now.
o Return later and set up other SNMP accounts. (For more
information on setting up an SNMP version 3 account, see the user
documentation).
Would you like to configure the SNMP management interface now?
[Y/N] y<Entrée>
To configure the SNMP management account you must specify
the management system IP address and the "community string" or
password that the particular management system uses to access the
switch. The wizard automatically assigns the highest access level
[Privilege Level 15] to this account. You can use Dell Open Manage
Network Manager or other management interfaces to change this
setting and to add additional management systems later. For more
information on adding management systems, see the User's Guide.
38
Guide de mise en route