Programming Remote Control; Direct Device Code Setup - ViewSonic CD4200 Guia Del Usuario

PROGRAMMING REMOTE CONTROL

Direct Device Code Setup

Although your Remote Control is set up to provide control of
this LCD, you can specify other devices to be controlled,
according to the following steps:
Each code in the following pages insists 5 digits from 0 to 9.
Mode → <<SET>> (2 blinks) → 5- digit device codes (2 blinks)
STEP 1 Locate the desired device in the Device code list.
STEP 2 Select the mode by pressing VCR, CBL, or AUX.
STEP 3 Depress and hold <<SET>> button for a minimum of 3 seconds until LED blinks
twice.
STEP 4 Enter the 5-digit code for the desired device. The LED blinks located on the
remote control once for every digit entered except for the last digit, where it shall
blink twice to confirm that a valid code has been programmed.
Mode
TV Locked to this LCD (Default)
VCR Universal VCR, DVD, PVR
CBL Universal Cable, Satellite, Video Accessory
Universal Tuner, Amplifier, CD, Mini Disc. And Misc. Audio,
AUX
Home Automation
Example: [VCR]→<<SET>> (2blinks)→[2]→[0]→[0]→[3]→ [5] (2 blinks).
NOTE 1 : Each digit must be entered within 10 seconds, or the Remote Control shall exit the current
programming state.
NOTE 2 : Two short LED blinks indicate valid code.
NOTE 3 : A long LED display indicates invalid code sequence. The code should be re-entered.
ViewSonic CD4200
Device Assignment
Device
Group no.
-------
2
0
3
33