Troubleshooting
The desk is not functioning properly.
It may need to be reset. Follow the Resetting the Handset procedure outlined in the Operation section.
The Handset LED displays "RST" (reset).
Follow the Resetting the Handset procedure outlined in the Operation section.
The Handset LED displays one of the following error codes:
Error Code
Error summary
E01
M1 overcurrent protection
E02
M2 overcurrent protection
E03
M3 overcurrent protection
E04
M4 overcurrent protection
E05
M5 overcurrent protection
E06
M6 overcurrent protection
E07
M1 hall error
To clear the error code, perform the Resetting the Handset procedure outlined in the Operation section. If the error message persists after a
reset procedure attempt, contact Tripp Lite support.
The Handset readout displays "HOT".
Allow the base to cool down for 20 minutes.
Specifications
Height Range
Desk Base Width
Travel Speed
Load Capacity
Duty Cycle
Certifications
Compliance
23.5" to 49" (Without Desk Top)
42.5" minimum to 72" maximum
1.5" per second (No Load)
220 lbs. @ 20,000 cycles
10%. Max. 2 minutes on 18 minutes off
Tested to UL 508, UL 1004-7, UL 1004-1, CSA C22.2.14-10, CSA C22.2.100-04, CSA 22.2.77-95
ANSI/BIFMA X5.5-2014 for Office and Institutional Furnishings
Error Code
Error summary
E08
M2 hall error
E09
M3 hall error
E10
M4 hall error
E11
M5 hall error
E12
M6 hall error
E13
Communication interrupt between controller A and B
H01
Overheat protection / Duty cycle protection
10
Capítulos
