Tabla de contenido
Technical Manual & Parts Lists
Efka Motor Parameter Settings
The parameters below are pre-programmed before the unit is shipped.
When replacing or installing a new Efka Controller, perform a master reset of the parameters
using the following instructions.
To Perform Master Reset of Parameters:
1. Power on holding down the "P" button till "COD" is displayed.
2. Press ">>" once and enter the number "5913"
3. Press "E" twice and "093" is displayed.
4. Press "+" once, "094" is displayed.
5. Press "P" to exit programming mode with all default values.
To modify the default parameters according to the table below, use the following instructions.
1. Power on holding down the "P" button till "COD" is displayed.
2. Press ">>" once and enter the number "3112"
3. Press "E" once and "2.0.0." is displayed this is a parameter
4. Proceed to the parameter to be changed and press "E"
5. The value now shows in the screen, adjust to desired value.
6. Press "E" to enter value and continue with parameter setting.
7. Repeat for other parameters, press "P" once when complete.
8. Run fusing head to save parameters before powering down
Parameter
290
111
119
161
240
270
272
26
401
Front panel LED's:
LED 1: Off
LED 2: Off
LED 3: Off
LED 4: Off
LED 5: Off
LED 6: Off
LED 7: Off
LED 8: On, Stop at needle up
18
Range
Value
5
200-9900rpm
2500
40911
1
0-1
0=CW
0-31
7
0-5
1
020-255
1000
0
1
Description
Mode Of Operation. MUST SET THIS
PARAMETER FIRST!
Maximum Speed when "129" is 0, 1, or 2
Linear Acceleration
Motor Rotation
Machine run blockage with closed contact
External handwheel sensor configuration
Drive ratio between motor pulley and
handwheel pulley. If handwheel pulley
is smaller than motor pulley, increase this
value to slow down sewing head until
measured speed matches speed
set with parameter 111. (For Yamato and
Pegasus, setting should be 100; for Rimoldi,
setting should be 124)
Tabla de contenido
