Installation Options; Option 1: Vehicle Installation - weBoost Drive 4G-S Manual Del Usuario

Installation Options

Option 1: Vehicle Installation

1. Attach the Mounting Bracket to the
vehicle's dashboard.
• Clean the area where the bracket is
to be mounted with the alcohol wipe
included. Allow the area to dry.
• Peel the backing to expose the adhesive
and press the bracket onto the desired
location on the dashboard. NOTE: Be
sure the tab is positioned vertically.
• Allow the adhesive to cure for 24 hours
before you attach the Drive 4G-S (Step
4).
2. Install the Outside Antenna. Select a
location on top of the car that is:
• Near the center of the vehicle's roof.
• At least 12 inches from any other
antennas.
• Free of obstructions.
• At least 6 inches from any windows
(including sunroofs).
• At least 8 inches from any people.
The Outside Antenna must be installed
vertically.
3. Run the Outside Antenna cable into the car.
The cable is strong enough that it may be
shut in most vehicle doors without damaging
the cable. For a cleaner look, carefully pull
down the door seal, run the cable under the
seal, and push the seal back into place. This
method reduces wear on the cable as the
door opens and closes.
Need help? www.weboost.com
4. Attach the Drive 4G-S to the Mounting
Bracket. After waiting 24 hours for the
adhesive on the bracket to cure, attach
the Drive 4G-S by aligning the rectangular
hole on the back of the Drive 4G-S with
the tab on the Mounting Bracket, grasping
the sides of the Drive 4G-S, and sliding it
downward approximately ¼ inch into place.
The Mounting Bracket is designed to
swivel for more convenient viewing
angles. Once the Drive 4G-S is in place,
you can adjust the angle of the bracket by
loosening the knurled nut, applying gentle
pressure to the top or bottom of the Drive
4G-S, and then tightening the nut when
the desired angle is achieved.
5. Attach the antenna to the Drive 4G-S.
Connect the cable from the Outside
Antenna to the antenna connector on the
bottom of the Drive 4G-S. Do NOT plug
in the power supply (next step) until the
Outside Antenna cable is connected to
the Drive 4G-S.
Note: The Drive 4G-S has a convenient
USB charging port located on the
right side of your booster. This port
allows for charging your phone or
device, using your existing cable.
Customer Support 866-294-1660
Mon.-Fri. 6 am to 7 pm. Sat. & Sun. 8 am to 5 pm MST
3