Installation And Connections - JB Systems AVM Serie Manual De Instrucciones

ENGLISH

INSTALLATION AND CONNECTIONS

Check if your VIBE-speaker is already prepared for use with the new AVM-amplifier modules: ONLY the
Mk2-serie is adapted for use with the AVM-amplifiers!
If you have an older cabinet, installation is quite complicated and should only be considered if you are a well
skilled person for the job. The installation inside older cabinets is not explained!
If your VIBE-speaker cabinet is prepared for easy installation of the AVM-modules than please proceed with
the installation as described below:
A. Unplug the passive VIBE-cabinet from the
amplifier and unscrew the screws that keep
the metal connector plate in place.
B. Keep the screws for later and remove the
connector plate: on the back you will notice
a special connector.
C. To disconnect the special connector, press
the connector lock and separate the two
connectors. Remove the original connector
plate and put the AVM-amplifier module in
place.
D. The amplifier module uses the same
connector as the original connector plate:
press the lock and join the 2 connector parts
together.
E. Make sure the lock function is on: you
should hear a "click". Double-check if the
connectors are well joined! If not, bad
connections could occur due to vibrations.
F. Put the amplifier module in place and use
the original screws to fasten the module.
FUNCTIONS
AVM-2 / AVM-3
JB SYSTEMS
®
3/30 AVM-AMPLIFIER MODULES
OPERATION MANUAL
AVM-1