Idiomas disponibles
Idiomas disponibles
Although the most common use of the transmitter buttons are shown on
the front page of this guide in bold face type, any button or button
combination can be programmed into any receiver channel. Additionally,
if both buttons are used and you require access to a 3rd channel or
function, you would program a combination of buttons to control the
3rd function.
i.e... you have programmed the large button for arm,
and the small button for disarm. For channel 3, or optional
function, you can program large and small buttons operated
simultaneously. Also, if you do not program a transmitter button into
channel 2 which is the separate unlock/disarm channel, then
whatever button is programmed into channel 1 will serve as both
arm & disarm, and if used, Lock & Unlock.
PROGRAMMING TRANSMITTERS:
NOTE:
Because the system may be capable of sounding a siren, the
vehicle horn, or both, where the siren chirp is referenced below, the siren
may chirp, the horn may beep, or both devices may sound.
NOTE:
It is important to remember that during the programming mode,
each individual step must be completed within 15 seconds of the previous
step. If the 15 second time limit expires between steps, the unit will
automatically exit the program mode. Any time the ignition key is turned
off while in the program mode, the system will immediately exit program
mode. Both 15 second expiration, and ignition turning off while in the
program mode will be indicated by a long chirp from the siren & or horn.
Non alarm models will flash the parking lights only to confirm the
transmitter code has been learned and stored.
TO PROGRAM ADDITIONAL TRANSMITTERS:
1. Enter the vehicle, and turn the ignition key to the "on" position.
2. Press and release the valet push-button switch three times.
3. The dash LED will flash once, and the siren will "chirp" once, indicating
the system is ready to accept programming for channel 1 or the arm/
disarm and panic functions.
4. You can assign any of the three transmitter button functions listed below
to channel 1.
a. Pressing button #1 on the keychain transmitter.
b. Pressing button #2 on the keychain transmitter.
c. Pressing both buttons simultaneously on the keychain transmitter.
5. Press and hold the selected choice a, b, or c above, until the siren emits
a long "chirp" to confirm that programming of channel 1 was successful.
6. Press and release the valet push-button switch one time.
7. The dash mounted LED will flash 2 times, and the siren will "chirp"
2
128-6463
2 of 16
