Positioning The Warning Lamp; Selecting A Flashing Scenario; Switching The Warning Lamp Off; Battery Service Life - Olympia WL9 Manual De Instrucciones

Positioning the Warning Lamp

Set or lay the warning lamp down on a suitable surface�
If you want to hang the warning lamp up, use the loop
or magnetic surface provided on the rear side�

Selecting a Flashing Scenario

The warning lamp is provided with 9 different flashing
scenarios as well as a torch function. Select the flashing
scenario in the following sequence:
360° rotating beacon à 3-flash mode à 1-flash mode
à alternating flash mode à SOS Morse code à pow-
erful continuous light à weak continuous light à contin-
uous light (2 LEDs) à continuous light (4 LEDs)
Press and hold the operating mode button on the front
of the warning lamp for about 2 seconds to switch the
warning lamp off�
Flashing scenarios
Press the operating mode button on the front of the
warning lamp, several times if necessary, to activate the
flashing scenario required.
Pay attention to the service life of the batteries in Chap-
ter "Battery Service Life"� Change the batteries when
the LEDs light up weakly or not at all�
Torch
The torch can be switched on individually or supple-
mentary to a light scenario�
1
Press the operating mode button on the front of the
warning lamp twice to switch the torch on�
2
Press the operating mode button on the front of the
warning lamp twice, again, to switch the torch off�

Switching the Warning Lamp Off

Press and hold the operating mode button on the front
of the warning lamp�The warning lamp is switched off�
8
G

Battery Service Life

The following table indicates the maximal service life
(operating period) of the batteries for continuous op-
eration. The values specified are guideline values and
could deviate depending on the environmental condi-
tions, quality and/or charge status of the batteries used�
Scenario
360° rotating beacon
3-flash mode
1-flash mode
Alternating flash mode
SOS Morse code
Powerful continuous light
Weak continuous light
Continuous light (4 LEDs)
Continuous light (2 LEDs)
Torch

Technical Data

Power supply
Flashing scenarios
Dimensions
Weight
Battery service life

Cleaning

Clean the surfaces of the housing with a dry, soft, lint-
free cloth� Do not use any solvents or cleaning agents�

Declaration of Conformity

Conformity of the equipment to the EU
directives is confirmed by the CE mark. The
Declaration of Conformity for this product is
available at www.olympia-vertrieb.de
Battery service life
8 hours
8 hours
25 hours
8 hours
12 hours
7 hours
20 hours
18 hours
25 hours
20 hours
3x batteries, AAA (1�5 V)
9 (via 12 LEDs)
105 x 105 x 35 mm
166 g (including batteries)
Refer to "Battery Service Life"