Battery Level Indicator; Automatic Time Setting - Bresser ClimaTemp FSX Manual De Instrucciones

Remote sensor
5. Remove the battery compartment cover.
6. Insert the batteries into the battery compartment. En-
sure that the battery polarity (+/-) is correct.
7. Move the CH slide control to the position for the desired
transmission channel (setting CH1, CH2 or CH3 with
screen display).
8. Replace the battery compartment cover.
NOTICE! When operating one outdoor sensor, channel 1
is recommended as the default setting.

8 Battery level indicator

1. When the level of the batteries in the base station or in
the wireless sensor reaches a critical level, the battery
level symbol appears in the appropriate area on the
display.
2. When replacing one set of batteries, always remove the
batteries from the other part of the unit and reinsert
them in the correct order (see chapter "Setting up
power supply"). Replace the batteries to be changed in
the corresponding part of the device with a completely
new set with full capacity. This ensures that the con-
nection between the devices will be reestablished again
correctly.

9 Automatic time setting

After the power supply was established, the clock will auto-
matically search for the radio signal. This will take approxim-
ately 3 to 8 minutes to finish this process.
11 / 108