Powermate PCV43 Manual Del Operador página 6

Assembly
• Save all instructions
Parts Included with Cultivator
• Middle Handle (1)
• Upper Handles (2)
• Wing nuts and bolts (4 ea.)
• Spark Plug Wrench & Rod (1)
WARNING
Do not operate cultivator if it is damaged or not securely and fully assembled.
How to Unpack Cultivator from Carton
1. Remove all parts and packing components.
2. Use a utility knife to cut all 4 vertical edges. Lay the side panels flat around the cultivator.
3. Remove inner components and packaging.
CAUTION
Use care when removing parts not to damage any cables or wires that are attached to the parts.
4. Roll the unit out from the carton, and place on a hard level surface.
How to Assemble the Handles and Drag Stake
Right Upper
Handle
Wingnut
Ignition
Cable
Wire
Ties
Lower
Handle
Middle Handle
1. Place the cultivator upright with tines and wheels on a hard level surface. Wheels should be set in the lowest position.
WARNING
Do NOT place the cultivator on a high surface where it can fall and cause property damage or personal injury.
2. Assemble the middle handle to the lower handle with the 2 bolts and wing nuts. Refer to Figure 1. Firmly hand-tighten
the wing nuts.
3. Attach the upper handles to the middle handle using the two remaining bolts and wing nuts. Refer to Figure 1.
4. Assemble the ignition switch and throttle trigger to the right upper handle with the screw. Use included wrench. See
Figure 1.
5. Make sure the ignition wire is connected to both the ignition switch (on the upper handle) and the engine. Make sure
the wires are connected at the white connection terminal.
6. Use the cable ties to secure the throttle cable and ignition wire to the handles.
7. The drag stake is shipped with the point facing upwards. To use for cultivating, remove detent pin, and turn the drag
stake upside down so the point faces downward. Re-insert the detent pin. Refer to Figure 2.
Questions? Call Toll Free at 1-800-737-2112
Throttle Wire
Left Upper
Handle
Bolt
Screw
Ignition Switch
If you need assistance or find any parts
missing, CALL TOLL FREE: 1-800–737-2112
• Cable Ties (3)
• Operator's Manual (1)
• 3.2 oz bottle of 2-Cycle engine oil (1)
* Wrench (1)
Detent Pin
Throttle
Trigger
Fig. 1
5
Drag stake
pointed down
Copyright © 2011 MAT Engine Technologies, LLC
Fig. 2