Anti-Tip Bracket; Model Icbuw-24 / Icbuw-24Fs Installation - Sub-Zero ICBUW-24 Guia De Instalacion

MODEL ICBUW-24 / ICBUW-24FS SITE PREPARATION

Anti-Tip Bracket

WARNING
To prevent the unit from tipping forward, the anti-tip
bracket must be installed.
MODEL ICBUW-24
The anti-tip bracket should be attached to the wall behind
the unit with the bracket flange located 6 mm above the top
of the unit. Refer to the illustration below. Failure to properly
position the anti-tip bracket will prevent proper engagement.
For installations that cannot accommodate the anti-tip
bracket, a countertop bracket is provided to secure the unit
to the countertop. Refer to the illustration below.
COUNTERTOP
ANTI-TIP BRACKET
BRACKET
6 mm
Anti-tip bracket (ICBUW-24). Countertop bracket.
4 | English
MODEL ICBUW-24FS
The back of the anti-tip bracket must be installed 625 mm
from the front and centered behind the unit. Refer to the
illustration below. Refer to page 10 for wood and concrete
floor applications.
ANTI-TIP BRACKET
Anti-tip bracket (ICBUW-24FS).

MODEL ICBUW-24 / ICBUW-24FS INSTALLATION

Custom Panel
MODEL ICBUW-24
For overlay applications, a custom door panel must be
installed. Panel size is critical for a proper fit. To verify panel
requirements and dimensions, refer to the Sub-Zero design
guide.
Finish all sides of the custom panel. They may be visible
when the door is open or through the glass door.
The custom overlay door panel is attached using screws
provided, through the door frame. Screw locations are
marked on the back of the custom panel using tenon cen-
ters inserted into holes of the door frame.
With the unit secured and door closed, hold the custom
panel in desired position on the door. Lightly tap the front
of the panel to locate mounting positions. Remove tenon
centers. Refer to the illustration below.
The door frame has mounting holes to accommodate
Sub-Zero accessory handles. If handle mounting holes are
not utilized, the handle should be attached to the custom
panel prior to mounting. Screw heads may need to be coun-
tersunk into the panel for proper alignment.
DOOR
GASKET
PANEL FRAME 11 mm
DIAMETER
TENON CENTER
6 mm
DIAMETER
Tenon center. Door frame cross section.
To mount the custom panel, open the door and use pre-
drilled holes to position the panel. Drive screws into the
panel through black tape on the door frame. Screw holes
are hidden behind the door gasket. Use as many screws as
necessary to secure the custom panel. Refer to the illustra-
tion below.
Adjustments can be made to the custom panel with a few
mounting screws in place, but not fully tightened. Once the
proper position is achieved, install and secure all screws.
Cover holes on the inside of the door frame with the cover
patches or plugs provided.
CAUTION
A solid panel cannot be installed over the glass door. A
solid door is available through an authorized Sub-Zero
dealer.
GLASS