Tabla de contenido
Idiomas disponibles
Idiomas disponibles
1.- Connect the cord to the electric supply.
2.- Press the power button (Button nº7).
3.- Place the screens parallel to the surface
to dry.
4.- Press the distance sensor (button nº1) to
place the equipment at the optimum working
distance.
5.- Place the equipment near the surface to be
dry up to the position where the L5 light stays
on.
6.- Approximate the equipment gently to the
piece until the L3 light is on. This will indicate
the optimal working distance (see section of
sensor operation).
7.- Block the rear wheels.
8.- Select pre-drying time (Button nº2). In this
phase, the emission of waves is intermittent.
9.- Select drying time at full capacity (Button
nº3). Continuous wave emission.
10.- Select number of lamps used (Button
nº4). Pressing repeatedly turn on or off the
lamps, being indicated by a light signal.
11.- Press the ON button (Button nº5) to start
the working cycle. The distance sensor will
automatically activate.
12.- An optical/acoustic signal will apprize the
completion of each of the phases and the
complete cycle.
PAUSE
To pause in the process, press Button nº6.
To continue the cycle, press the ON button
again (button nº5). For security reasons the
distance sensor is activated automatically.
To finally stop the cycle press the off button
again.
INTERRUPTION
To complete interruption of the drying process,
double-click OFF (Button nº6).
4. INSTRUCTIONS FOR USE
- 15 -
L1
L2
L3
L4
L5
1
2
3
4
5
6
7
Tabla de contenido
