Supply; Technical Specifications; Installation; Adjustment - Vortice PIR SYSTEM Manual De Instrucciones

ENGLISH
• Do not operate the appliance where inflammable vapours or substances are present (alcohol, insecticides,
petrol, etc.)
!
Caution:
this symbol indicates precautions that must be taken to avoid damaging the appliance.
• Do not make modifications of any kind to the appliance.
• Do not expose the appliance to the weather (rain, sun, etc.).
• Periodically inspect the appliance for damage. If any faults are found, do not operate the appliance; contact
VORTICE immediately.
• In the event that the appliance is dropped or suffers a heavy blow, have it checked immediately by VORTICE
• Se l'apparecchio cade o riceve forti colpi farlo verificare subito presso un Centro Assistenza Tecnica
autorizzato VORTICE.
• L'impianto elettrico a cui è collegato il prodotto deve essere conforme alle norme vigenti.
• L'apparecchio non necessita di collegamento ad una presa con impianto di messa a terra in quanto è costruito
a doppio isolamento.
• Check that the electrical power supply/socket provides the maximum electrical power required by the
appliance. If this is not the case, arrange for a qualified electrician to make the necessary modifications.
• Switch off the appliance at the main switch:
a) if the appliance does not function correctly;
b) before cleaning the outside of the appliance,
c) if the appliance is not to be used for any length of time.
• This symbol indicates that the operation must be carried out by a suitably qualified person.
Supply (fig. 0)
- PIR SYSTEM unit
- Installation accessories: 2 fixing inserts, 4 M6x10 grub screws: 1 clamp
Note: The cables required for connection to the mains and UVLOGIKA SYSTEM, not included in the supply,
must have the following characteristics: nominal cross-section: 3x0.75 mm2 (outer Ø = 7 mm).

Technical specifications

Power supply: single phase 220-240 V ~ 50/60 Hz.
Maximum permissible load: 3 A.

Installation

Fig. 1-14

Adjustment

The circuit of the PIR SYSTEM, in the event of presence of people, deactivates the lamp to which it is connected
for an adjustable time from 3 to 20 minutes (factory setting=3 min). To adjust the trimmer, follow the sequence in
figure 12.
The lamp will therefore remain off for the set interval and will only turn on again only if there are no people in the
room; if after this set time, people will still be detected inside the room, the lamp will remain off for another cycle.

Maintenance and cleaning

For device maintenance or replacement, contact an authorised VORTICE T echnical Service Centre.
The product does not require special cleaning. Remove dust from the accessory with a clean cloth or compressed
air after disconnecting the unit from the mains.
8