Starting The Tool; Before Use - Holmatro PSP40 Manual

EN
5.5

Starting the tool

• Push the on/off switch of the battery to start the tool. The LEDs for the temperature, State of Charge
and the LEDs of the tool will come on.
• The tool operates if the deadman's handle is turned to position
NOTICE
When the tool is not used for 10 minutes the battery pack will stop. Push the on/off switch to
start the tool again.
5.6 Operate the deadman's handle
The deadman's handle is used to determine the movement of the plunger(s). If the deadman's handle is
released, it returns automatically to the neutral position and stops the hydraulic pump. The tool stops.
In the initial movement of the deadman's handle the motor operates slowly. Movement of the tool will be
slow for maximum control. When the deadman's handle is rotated further the motor will operate at
maximum speed.
Pressure is built up in the tool. Return oil from the tool flows back to the pump without pressure.
The pump will stop at maximum pressure to save energy. Release and operate the deadman's handle
to start the tool again.
/i
Hold the deadman's handle in this position to extend / open the tool.
Hold the deadman's handle in this position to retract / close the tool.
5.7 Operating the light switch
On the tool is a light switch for the integrated LED lights.
• Push the light switch to stop or start the LED lights.
NOTICE
When the tool starts, the LEDs come on by default.
6 Use
6.1 General
The equipment of a rescue system must always be ready for use. That means the equipment must be
checked and inspected directly after use, before it is put away.
WARNING
Make sure you are up to date on all safety regulations and that you have mastered the use of
all equipment of the system you are going to work with.
6.2

Before use

• Before use, always check the State Of Charge of the battery pack. See section 3.6.2.
46 916.400.097_002
or .
PSP40