EMKO ESM Serie Manual Del Usuario página 11

: Alarm Hysteresis value. It can be adjusted from %0 ile %50 of the Scale
( -
: Alarm Type selection. (Default:
: Alarm Set Low Limit parameter. It can be adjusted from Operation Scale minimum
to Alarm Set High Limit. (Default: 0)
: Alarm Set High Limit parameter. It can be adjusted from Alarm Set Low Limit to
Operation Scale maximum. (Default: 500)
: Alarm on Delay Time. It can be adjusted from 0 to 9999 seconds. (Default: 0)
: Alarm off Delay Time. It can be adjusted from 0 to 9998 seconds. If it is higher than
9998, is seen on the screen and Alarm Latching Output is selected. (Default: 0)
NOTE: Alarm-2 parameters(AHS2 , AtS2 , Alo2 ,AuP2 , Aon2 , AoF2 )
are active,if Cout parameter is set as SSR.
: Protection Menu Parameter
: Password for accessing to the programming section. It can be adjusted from 0 to
9999. If is 0, password screen is not observed. If
enters to the menu pages without entering the password, all the menus can be observed
except protection menu
parameters. (Default value is 0)
Alarm Types
Alarm
Output
Process High
Alarm
Alarm
Output
Process Low
Alarm
). (Default: 0)
. But device does not allow to do any changes in
ON
OFF
ON
OFF
)
is different from 0 and user
Process Value
Process Value
11