Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Features (Continued)
USING YOUR GARAGE DOOR OPENER
The garage door opener can be activated through a wall-mounted
door control, remote control, wireless keyless entry or Smart
Control accessory.
When the door is closed and the garage door opener is activated
the door will open. If the door senses an obstruction or is
interrupted while opening the door will stop. When the door is in
any position other than closed and the garage door opener is
activated the door will close. If the garage door opener senses an
obstruction while closing, the door will reverse. If the obstruction
Door Control
SYNCHRONIZE THE DOOR CONTROL
To synchronize the door control to the garage door opener, press
the push bar until the garage door opener activates (it may take
up to 3 presses). Test the door control by pressing the push bar,
each press of the push bar will activate the garage door opener.
USING THE DOOR CONTROL
Push Bar
1 Minute,
5 Minute,
and 10
Minute TTC
LED
Push Bar
Press the push bar to open or close the door.
Light Button
Press the LIGHT button to turn the garage door opener lights on
or off. When the lights are turned on they will stay on until the
LIGHT button is pressed again, or until the garage door opener is
activated. Once the garage door opener is activated the lights will
turn off after the specified period of time (the factory setting is 4-
1/2 minutes). The LIGHT button will not control the lights when
the door is in motion.
The duration of the light timing can be adjusted using the door
control.
interrupts the sensor beam the garage door opener lights will
blink 10 times. However, you can close the door if you hold the
button on the door control or keyless entry until the door is fully
closed. The safety reversing sensors do no effect the opening
cycle.
The safety reversing sensor must be connected and aligned
correctly before the garage door opener will move in the down
direction.
The following features are accessible through the screen
using the navigation buttons on the Smart Control Panel:
LEARN A DEVICE
Any compatible remote controls, wireless keyless entry, or Smart
Control accessories can be programmed to the garage door
opener by accessing the menu and using the navigation buttons
on the Smart Control Panel.
Lock
The LOCK feature is designed to prevent activation of the garage
door opener from remote controls while still allowing activation
from the door control and keyless entry. This feature is useful for
added peace of mind when the home is empty (i.e. vacation).
HOLD Button for
Timer-to-Close (TTC)
the Timer-To-Close
DO NOT enable TTC if operating a one-piece door. TTC is to be
(TTC)
used ONLY with sectional doors.
Factory default is set to off. TTC can be set to automatically close
LIGHT
your garage door from the fully open position after a specified
Button
period of time (1, 5, 10 minute intervals). The garage door opener
will beep and the lights will flash before closing the door. If the
Motion
door encounters an obstruction while closing, the garage door
Sensor
opener will make a second attempt to close the door. If the
obstruction has not been cleared after the second attempt, the
garage door opener will reverse open, stop and WILL NOT close
until the obstruction has been cleared. TTC WILL NOT work if the
garage door opener is operating by battery power or if the safety
reversing sensors are misaligned. This feature is NOT intended to
be the primary method of closing the door. A keyless entry
should be installed in the event of an accidental lock out
when using this feature.
AUTOMATIC LIGHT
Motion Sensor
Factory default is set to on. This feature will automatically turn on
the garage door opener lights when motion is sensed. The lights
will come on for the set period of time, then shut off.
If using the garage door opener light as a work light disable the
Automatic Light Feature, otherwise the light will turn off
automatically if you are beyond the range of the sensor.
Light Feature
The lights will turn on when someone enters through the open
garage door and the safety sensor infrared beam is broken.
32
Capítulos
Tabla de contenido
