Operation; Using Your Garage Door Opener - Craftsman 139.53910 Manual Del Propietário

OPERATION

IMPORTANT SAFETY INSTRUCTIONS
.. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. ..
To reduce the risk of severe injury or death:
1. READ AND FOLLOW ALL WARNINGS AND
INSTRUCTIONS.
2. ALWAYS keep remote controls out of reach of children.
NEVER permit children to operate or play with garage
door control push buttons or remote controls.
3. ONLY activate garage door when it can be seen clearly, it
is properly adjusted, and there are no obstructions to
door travel.
4. ALWAYS keep garage door In sight until completely
closed. NO ONE SHOULD CROSS THE PATH OF THE
MOVING DOOR.
5. NO ONE SHOULD GO UNDER A STOPPED, PARTIALLY
OPENED DOOR.
6. If possible, use emergency release handle to disengage
trolley ONLY when garage door is CLOSED. Weak or
broken springs or unbalanced door could result in an
open door falling rapidly and/or unexpectedly.
7. NEVER use emergency release handle unless garage
doorway is clear of persons and obstructions.
8. NEVER use handle to pull garage door open or closed. If
rope knot becomes untied, you could fall.

Using Your Garage Door Opener

Your Security+® opener and hand-held remote
control have been factory-set to a matching code
which changes with each use, randomly accessing
over 100 billion new codes. Your opener will operate
with up to eight Security*® remote controls and one
Security*® Keyless Entry System. If you purchase a
new remote, or if you wish to deactivate any remote,
follow the instructions in the
Programming
Activate your opener with any of the following:
•
The hand-held Remote Control:
push button down until the door starts to move.
•
The wall-mounted Door Control:
button or bar down until the door starts to move.
• Entry
The Keyless (See Accessories):
with your garage door opener, it must be
programmed before use. See
W hen the opener is activated (with the safety
reversing sensor correctly installed and aligned)
1. If open, the door will close, if closed, it will open.
2. If closing, the door will reverse.
3. If opening, the door will stop.
4. If the door has been stopped in a partially open
position, it will close.
5. If obstructed while closing, the door will reverse. If
the obstruction interrupts the sensor beam, the
opener lights will blink for five seconds.
9. If one control (force or travel limits) is adjusted, the
10. After ANY adjustments are made, the safety reversal
11. Safety reversal system MUST be tested every month.
12. ALWAYS KEEP GARAGE DOOR PROPERLY BALANCED
13. All repairs to cables, spring assemblies and other
14. ALWAYS disconnect electric power to garage door
15 SAVE THESE INSTRUCTIONS.
6. If obstructed while opening, the door will stop.
7. If fully open, the door will not close when the beam
If the sensor is not installed, or is misaligned, the
door won't close from a hand-held remote. However,
you can close the door with the Door Control, the
Outdoor Key Switch, or Keyless Entry,
them until down travel is complete.
section.
them too soon, the door will reverse.
The opener lights
Hold the large
conditions: when the opener is initially plugged in;
when power is restored after interruption; when the
Ftold the push
opener is activated.
Lights will also turn on when someone walks through
If provided
the open garage door.
They will turn off automatically after 4-1/2 minutes.
Programming.
Bulb size is 75 watts maximum.
30
.. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. ..
other control may also need adjustment.
system MUST be tested.
Garage door must reverse on contact with 1-1/2' high
(3.8 cm) object (or a 2x4 laid flat) on the floor.
(see page 3). An Improperly balanced door may not
reverse when required and could result In SEVERE
INJURY or DEATH.
hardware, all of which are under EXTREME tension,
MUST be made by a trained door systems technician.
opener BEFORE making any repairs or removing
covers.
is broken. The sensor has no effect in the opening
cycle.
will turn on under the following
if you activate
If you release