Idiomas disponibles
Idiomas disponibles
Step 1: Screw the bulb securely into socket.
Installing the bulb
Step 2: Back the bulb out one or two turns, then screw bulb back to insure
proper position in socket.
Step 3: Fasten lens cover to lens assembly by placing
the lens cover in the groove of the lens assembly
and twisting clockwise until it stops. Tighten
locking screw in lens cover with phillips screw
driver to secure. Do not over tighten.
Caution: Lens cover must be attached before using
fixture (Fig. 4).
Step 1: Make sure the screw in the center of receptacle
Installing the light sensor
(on top of fixture) is tight.
Step 2: Match up the largest prong on the sensor to the largest slot
in the receptacle.
Step 3: Push sensor down into receptacle and twist clockwise
1/4 of a turn to lock in place (Fig. 5).
Step 4: Turn on the main power at the main fuse/breaker box.
Note: When power is initially turned on, the light may come on,
even during daylight. However, the light will turn off after two or
three minutes and will only come on at dusk thereafter. If artificial
light sources (such as car headlights) come in contact with the
photo control, it may activate the photo control and turn off the
fixture. If this occurs, the fixture will have to cool down for
approximately 5 minutes before it will come on again.
Call for customer service and/or missing or damaged parts (800-334-6871)
4
Fig. 4
Fig. 5
