Bang & Olufsen BEOLAB 28 Guia Del Usuario página 10

B E O L A B 2 8
A C C E S S P O I N T ( A P ) R E S E T
You can connect your Beolab 28 to a new wireless network or reset the connection,
by holding the next and previous buttons on the top plate at the same time for 3
seconds. You will hear a sound prompt and the status indicator will turn amber.
In the product settings of the Bang & Olufsen app, select Re-Setup to connect the
speaker to Wi-Fi.
F A C T O R Y R E S E T
You can restore factory settings by pressing and holding the next and previous
buttons on the top plate at the same time for 8 seconds. You can let go when the
status LED flashes red.
Your speaker will begin the reset process and after approximately one minute, your
Beolab 28 will be ready for first-time set-up again.
C U R T A I N S
The curtains move as your Beolab 28 turns on or off as well as shows the beam
width.
You can exchange the curtains, if you would at some point like to change the
appearance of your Beolab 28.
Be aware, that if you manually move the curtains of your Beolab 28 there is a
possibility that they will detach from the brackets in either the bottom or the top.
If the curtains are not mounted correctly there is a risk they can fall off during
movement and will be damaged.
If you move the curtains manually, make sure that they are still properly attached to
the top and bottom, you will hear a "click" sound as they snap into place.
Find instructions for how to assemble and detach your curtains here.
1 0