melitta Aroma Elegance Instruciones De Uso página 7

Hardness setting
°dH
ONLY AromaElegance
®
LED flash rhythm
(DECALC/HARDNESS button )
ONLY AromaElegance
®
DeLuxe: Display
Table 1
understood the potential hazards.
• C hildren must not play with the
appliance
• R eplacement of the power cable
and all other repairs may only be
carried out by Melitta
mer Service or by an authorised
repair shop.
Insulated jug
• D o not use the jug in the micro-
wave.
• D o not place the jug on a hot
stove.
• D o not use the jug to store
dairy products or baby food,
as there is a risk of bacterial
growth.
• D o not lay the filled jug on its
side, as liquid may escape.
• C lean the outer casing with a
soft, damp cloth.
ONLY for plastic jugs with
glass insert
• T o prevent damage to the glass
flask, do not use hard or sharp-
edged objects (e. g. cutlery,
dishwashing brushes or similar)
for stirring or cleaning and
do not fill with ice cubes or
carbonated liquids.
• D o not subject the glass flask to
high temperature fluctuations.
I
<7°
dH
Therm:
............
Therm
1
Custo-
®
II
14-21°
7-14° dH
............ ............
2
2. Before first use
• Ensure that the power supply in your home
corresponds to that on the model plate on the
base of the appliance.
• Connect the appliance to a power source. Unused
cable can be stored in the base of the appliance .
• Only Melitta
®
Set the current time using the H and M buttons .
This goes faster if you hold down the button. The
appliance is only ready for use after setting
the time. By simultaneously holding down the H
and M buttons  for longer than two seconds, you
can turn the display light on or off.
• All appliances have been tested during production
to ensure they work perfectly. Therefore there may
be for example water deposits remaining. Rinse the
appliance twice with the maximum amount of water
and without a filter bag or ground coffee, in order to
clean it.
• For the best coffee enjoyment and convenient use,
the appliance is equipped with various features.
These features are explained below.
3. Set water hardness
Depending on water hardness lime scale may build up
in the appliance. This increases the appliance's energy
consumption as lime scale on the heating element can
prevent the water heating effectively. To avoid damage
the appliance must be descaled regularly.
The descaling display helps you with this .
If the red LED is permanently lit this shows that the
appliance needs to be descaled (see point 6).
The appliance is pre-set for a high level of water
hardness (level 4). You can find out the level of water
hardness in your area by asking your local water
provider or by using water hardness measuring strips
available in the shops. For softer water the descaling
display can be adjusted to descale less often:
Melitta AromaElegance
®
• Hold down the DECALC/HARDNESS button 
for longer than two seconds. The red LED will start
to flash. In the factory settings the LED flashes four
times with the following pauses (......).
• You can set the water hardness at three other levels.
By briefly pressing the DECALC/HARDNESS but-
ton  the display changes to flashing briefly once,
twice or three times, each time followed by a pause
(......, ......, ......).
• The settings and display are shown in table 1.
• Once you have set the desired level of water
hardness, hold down the DECALC/HARDNESS
III IV
>21°
dH dH
............
3
AromaElegance Therm DeLuxe:
®
Therm
®
GB
4
9