Tabla de contenido
Idiomas disponibles
Idiomas disponibles
CONTACTING POLO
Website:
www.polo-motorrad.de
Email:
Mailing Address:
Polostr. 1
D-41363 Jüchen
ABOUT PM750 Each process is uncomplicated and easy
to accomplish. The PM750 is designed for charging all
types of 6V & 12V lead-acid batteries, including Wet
(Flooded), Gel, MF (Maintenance-Free), CA (Calcium),
EFB (Enhanced Flooded Battery), and AGM (Absorption
Glass Mat) batteries. It is suitable for charging battery
capacities from 2 to 30 Amp-Hours and maintaining all
battery sizes.
GETTING STARTED Before using the charger, carefully
read the battery manufacturer's specific precautions
and recommended rates of charge for the battery. Make
sure to determine the voltage and chemistry of the bat-
tery by referring to your battery owner's manual prior to
charging.
MOUNTING The PM750 is a direct wall plug-in charger,
and it is important to keep in mind the distance to the
battery. The DC cable length from the charger, with ei-
ther the battery clamp or eyelet terminal connectors, is
approximately 75-inches (1,900mm).
CHARGING MODES The PM750 has three modes: Stand-
by, 12V NORM, and 6V NORM. Some charge modes must
be pressed and held for three seconds to enter the mode.
These "Press and Hold" modes are advanced charging
modes that require your full attention before selecting.
"Press and Hold" are indicated on the charger by a red line.
It is important to understand the differences and purpose
of each charge mode. Do not operate the charger until you
confirm the appropriate charge mode for your battery. Be-
low is a brief description:
Mode
In Standby mode, the charger is not
charging or providing any power to
the battery. Energy Save is activated
Standby
during this mode, drawing microscopic
power from the electrical outlet. When
selected, an orange LED will illuminate.
No Power
For charging 12-volt Wet Cell, Gel Cell,
12V
Enhanced Flooded, Maintenance-Free
NORM
and Calcium batteries. When selected,
a white LED will illuminate.
14.5V | 750mA | 2-30Ah Batteries
For charging 6-volt Wet Cell, Gel Cell,
Enhanced Flooded, Maintenance-Free
6V
and Calcium batteries. When selected,
NORM
a white LED will illuminate.
7.25V | 750mA | 2-30Ah Batteries
Press & Hold
USING 6V NORM [PRESS & HOLD]
6V NORM charge mode is designed for 6-volt lead-acid
batteries only, like Wet Cell, Gel Cell, Enhanced Flooded,
Maintenance-Free and Calcium batteries. Consult the
battery manufacturer before using this mode.
CONNECTING TO THE BATTERY
Do not connect the AC power plug until all other con-
nections are made. Identify the correct polarity of the
battery terminals on the battery. The positive battery
terminal is typically marked by these letters or symbol
(POS,P,+). The negative battery terminal is typically
marked by these letters or symbol (NEG,N,-). Do not
make any connections to the carburetor, fuel lines, or
thin, sheet metal parts. The below instructions are for a
negative ground system (most common). If your vehicle
Explanation
15
Tabla de contenido
