2. Safety Information
• Use Outdoors Only!
• Do not move the appliance while in use.
• The parts sealed by the manufacturer or its agent must not be altered
by the user.
NOTE
• Do not twist or pinch the hose. Ensure that it is kept away from the
BBQ body so as to prevent deterioration/damage to the hose caused by
heat.
• Ensure that the connections are made securely and do not allow gas to
leak.
• Check for gas leaks before using the appliance.
• For use with an approved hose and regulator connected to a refi llable
gas container not exceeding 20lb and complying with local regulation
in force.
• Do not obstruct the ventilation openings of the cabinet.
• Do not modify the appliance. Modifying the appliance may be
dangerous.
• Warning: An LP cylinder not connected for use shall not be stored in the
vicinity of this or any other appliance.
3. Using the Appliance
•
Place the cylinder inside the cabinet through the back of the cabinet
into the allocated space.
•
Use this appliance only on a fi rm level surface.
•
Before use ensure that the drip cup is in place.
•
Make sure the gas cylinder is correctly fi tted to the appliance.
•
Ensure the cylinder control valve is in the open position.
•
Note! All burners are fi tted with an automatic igniter.
To light the appliance using the automatic igniter, fi rst ensure the
dome is in the open position. Push in and turn the control knob in an
anti-clockwise direction until spring resistance is felt. Hold the knob
in this position for 3 – 5 seconds to allow the gas to fl ow and then turn
the knob fully anti-clockwise to the HIGH position. This will cause the
automatic lighter to light the burner. Should the burner not ignite the
fi rst time, turn the control knob to the OFF position and wait 5 minutes,
repeat the process until the burner ignites.
•
Manual ignition: To light the burners manually, fi rst remove the grill
plate and the defl ector plate directly underneath it. Ignite a match or
fi relighter and position it next to the left hand burner. Turn on the gas
supply to that burner only by pushing the control valve in and turning
it in an anti-clockwise direction. This will ignite the burner. Once the
burner is ignited, carefully replace the defl ector plate and cast iron
grill plate. You will now be able to light the remainder of the burners as
above.
•
Use the control knobs to adjust the individual burner fl ame intensity
to the desired level by turning the knob anti-clockwise to decrease the
fl ame and clockwise to increase it (see Fig. 3).
•
After use, fi rst close the valve on the gas cylinder. When the fl ame
is extinguished, close the burner control valves on the appliance by
turning control knobs fully clockwise.
503-0644 LEV2 - (20163) Meridian 3 Woody - User Manual (USA).indd 2
Regulator
Hose
Hose
connection
to appliance
20lb Cylinder
2 2
GB
Fig. 1
Fig. 2
Fig. 3
Fig. 3
24/02/2017 12:23:29