Appendix; Connecting Jongo To Your Wireless Network Using Push Button Configuration; Using A Chargepak F1 - PURE Jongo S3 Manual Del Usario

Appendix

Connecting Jongo to your wireless network using Push Button
Configuration
You can use Push Button Configuration to connect Jongo to your wireless network if WPS is supported by
your router. Refer to your router user guide for more information on WPS.
1. Press the WPS button on your router.
2. Press and hold the WiFi button on the rear of Jongo until Jongo's Power light pulses green. Jongo will
attempt to connect to your network.
3. When Jongo's Power light is steady green, Jongo has successfully connected to your network using Push
Button Configuration. You will now be able to start streaming tracks to Jongo. See page 9.
Note: The Power light on Jongo will flash red if Jongo doesn't establish a Push Button Configuration
connection within 2 minutes.
Note: The WPS function in some WPS-compatible routers may be disabled by default. Consult your router
documentation for more information.

Using a ChargePAK F1

ChargePAK F1 makes Jongo truly portable, so you can enjoy the programmes you love in the garden or at
the beach.
Because it's rechargeable ChargePAK is much cheaper than regular batteries. It's also more eco-friendly
because it reduces the amount of toxic substances sent to landfill. And, because it's a fit-and-forget
solution that charges whenever Jongo is connected to the power outlet, it's much more convenient than
standard rechargeable batteries.
When Jongo is being powered by a ChargePAK F1, Jongo will only remain in the sleep state for five
minutes before powering off if it does not receive any audio.
12
Replacing the ChargePAK F1
1. Switch Jongo off and disconnect from the mains power supply.
2. Turn Jongo upside down and use a screwdriver to open the
battery compartment on the base of Jongo.
3. Replace ChargePAK so that the Pure label is facing the battery
compartment lid and the ChargePAK contacts line up with the
three terminals in the battery compartment.
4. Replace the battery cover and secure with the screw, ensuring
that the screw is not over-tightened, and connect your product
to a power supply.
5. ChargePAK will begin charging.
Note: When charging your ChargePAK for the first time or
after an extended period of inactivity it is recommended that it
is charged for around 24 hours to ensure full battery power. If
ChargePAK is completely flat, there may be a slight delay before
the battery charging indicator is displayed.
Note: It is normal for your ChargePAK to get warm, especially
during charging. Your ChargePAK will give years of trouble-free use
under normal circumstances, but like all rechargeable batteries its
efficiency will gradually reduce with age.
Important: Jongo can only be powered with a Pure ChargePAK F1
and is not compatible with any other batteries, either disposable or
rechargeable, or any other ChargePAK model.