Maintenance And Care; Spare Parts And Accessories; Transport; Conformity - Flex ID 1/4" 18.0-EC Instrucciones De Funcionamiento Originales

IW 1/2" 18.0-EC / ID 1/4" 18.0-EC / IW 3/4" 18.0-EC
 Pull out the mains plug.
NOTE
If the display flashes after the battery is
inserted in the charger, there is a fault in the
battery or in the charger.
Display flashes slowly.
Backlighting orange.
The battery is too hot or too cold. The charging
process starts when the battery reaches the
charging temperature (0°C...55°C).
Display flashes rapidly.
Backlighting red.
Remove the battery from the charger and
insert again. If the same display persists, the
battery is faulty. Replace the battery or have
it checked at an authorised repair shop.
If this error message is displayed again with
a different battery, this indicates that there
is a fault in the charger. Have the charger
checked at an authorised repair shop.

Maintenance and care

Cleaning
WARNING!
If metals are worked over a prolonged
period, electroconductive dust may become
deposited inside the housing.
Clean the power tool and ventilation slots at
regular intervals. Frequency of cleaning is
dependent on the material machined and
the duration of use.
 Regularly blow out the housing interior
and motor with dry compressed air. Keep
the power tool running while doing this.
Charger
WARNING!
Before performing any work, pull out
the mains plug. Do not use water or liquid
detergents.
 Remove dirt and dust from the housing
with a brush or a dry cloth.
Repairs
Repairs may be carried out by an authorised
customer service centre only.

Spare parts and accessories

For other accessories, in particular cutting
accessories, please refer to the
manufacturer's catalogues.
Exploded drawings and spare-part lists can
be found on our homepage:
www.flex-tools.com

Transport

The lithium equivalent content of the batteries
contained in the scope of delivery is below the
relevant limit values. Therefore the battery as
a separate component and the power tool with
its scope of delivery are not subject to national
or international dangerous goods regulations.
If several devices containing lithium-ion
batteries are transported, these regulations
may become relevant and require special
safety measures (e.g. for the packaging).
In this case acquaint yourself with the
regulations that apply to the country of use.

conformity

We declare on our sole responsibility that the
product described in "Technical data"
conforms to the following standards or
normative documents:
EN 62841 according to the provisions of
Directives 2014/30/EU, 2006/42/EC,
2011/65/EU.
Responsible for technical documents:
FLEX-Elektrowerkzeuge GmbH, R & D
Bahnhofstrasse 15, D-71711 Steinheim/Murr
18.12.2017; FLEX-Elektrowerkzeuge GmbH
Bahnhofstrasse 15, D-71711 Steinheim/Murr
23