Indoor Unit Installation; Prior To Installation - Orbegozo FDI 94 Manual De Instalación

FDI 94 FDI 124 FDI 184 FDI 244 MANUAL DE INSTALACIÓN

INDOOR UNIT INSTALLATION

PRIOR TO INSTALLATION - Before installing the indoor unit, refer to the label on the product box to make sure
that the model number of the indoor unit matches the model number of the outdoor unit.
STEP 1: SELECT INSTALLATION LOCATION
Before installing the indoor unit, you must choose an appropriate location. The following are standards that
will help you choose an appropriate location for the unit.
 Good air circulation
 Convenient drainage
 Noise from the unit will not disturb other people
 Firm and solid—the location will not vibrate
 Strong enough to support the weight of the unit
 A location at least one meter from all other electrical devices (e.g., TV, radio, computer)
DO NOT install unit in the following locations:
 Near any source of heat, steam, or combustible gas
 Near flammable items such as curtains or clothing
 Near any obstacle that might block air circulation
 Near the doorway
 In a location subject to direct sunlight
NOTE ABOUT WALL HOLE
If there is no fixed refrigerant piping:
While choosing a location, be aware that you should leave ample room for a wall hole (see Drill wall hole for
connective piping step) for the signal cable and refrigerant piping that connect the indoor and outdoor units.
The default position for all piping is the right side of the indoor unit (while facing the unit). However, the unit
can accommodate piping to both the left and right.
INSTALLATION INSTRUCTIONS – INDOOR UNIT
46