Idiomas disponibles
Idiomas disponibles
I
MPORTANT FOR THE INSTALLER
The control unit has been designed to allow the installer to automise
fastening in order to submit to regulatory prescriptions. The effective
compliance with the obligations and achievement of the minimal safe-
ty requirements are, however, the responsibility of the installer. Once
installation is completed in compliance with EN 60335-2-97 " Safety of
household and similar electrical appliances" part 2 " Particular require-
ments for drives for rolling shutters, awnings, blinds and similar equip-
ment", it is necessary to verify that:
There are no accidental movements
There are no unwanted movements due to power supply voltage vari-
ation.
The impact force of the main closing edge does not exceed:
- 25 N for more than 5s
-150 N for more than 0.5s.
In case the latter indication is not satisfied, it is alternatively possible,
through the Operator present functioning, to use the radio-controls to
obtain a release control type operation without self-hold. Although in
this case it is essential to use the radio-control only when in the fasten-
ing is perfectly visible (wall mounted).
It is also recommended to comply with the following warnings:
- For a correct functioning of the radio receiver, in case of using one
or more control units, the installation at a minimum distance of at least
3 metres one from the other is recommended.
-
The control unit does not show any type of isolating device, it will
therefore be the responsibility of the installer to arrange an isolating
de-vice inside the plant. It is necessary to install a single-phase switch
with over-voltage category III. It must be positioned so as to be pro-
tected against accidental closures.
The product:
LRS 2217/M – LRS 2217/M SET Electronic Control Unit
is in compliance with the specifications of the RED 2014/53/EU ,
EMC 2014/30/EU and LVD 2014/35/EU Directives.
- 8 -
Rev. 3.0
13/06/2016
