Tabla de contenido
Idiomas disponibles
Idiomas disponibles
The Belt
The belt on your vacuum cleaner controls the speed of the revolving
brush and is very important for the effective operation of the cleaner. If
the belt becomes stretched or cut, it will cause the revolving brush to stop
completely or slow down. See instructions in the manual for replacing
belt.
An extra belt is stored in the baseplate of your cleaner. When buying
replacement belts, use ONLY ORECK genuine belts. Belts other than
ORECK belts will not operate the revolving brush correctly and may
create undue stress which will cause damage to the motor and brush
bearings. Using belts other than ORECK belts will void the warranty.
Lubrication
The vacuum cleaner motor bearings are factory lubricated and seated.
Further lubrication is not required.
General Cleaner Care
CAUTION—Wood Floors, Soft (Vinyl, Asphalt Tile, etc.) Floor
Surfaces and Polished Floor Finishes
Use floor and floor finish manufacturer's recommended methods of
cleaning. The metal strip on the base of the cleaner could be damaged if
used on concrete or abrasive surfaces, and, therefore, cause damage to
wood floors, soft (vinyl, asphalt tile, etc.) floor surfaces and polished
floor finishes. The roller brush may also scuff very soft finishes. Do not
operate the unit while in the upright and locked position. Do not let the
unit run while in any one stationary position for any period of time. Keep
the unit moving while in operation.
E
N
G
At least once a month, check for
and remove excessive lint, string or
hair from revolving brush.
Wipe the outside of the cleaner with
a damp cloth. Also clean the
connector deflector assembly area,
base of cleaner and fan housing
area. If there is dust in the outer
bag, vacuum it or shake it out.
A little preventative maintenance will
keep your cleaner looking new and
will ensure continued cleaning
effectiveness.
L
I
S
H
T
R
o
eplace
D
WARNING: Unplug cord from electrical outlet
before servicing
5
F
ilter
B
ust
ag
.
BAG REMOVAL:
1. Pull bag cardboard collar to release
bag dock door from connector.
2. Gently pul bag cardboard collar
upward out of the bag dock.
BAG INSTALLATION:
1. Slide the cardboard collar
completely onto bag dock door.
PRESS
UNTIL SNAP
IS HEARD
ENFONCEZ JUSQU'À
E N T E N D RE U N BRU I T
PRE S I O N E HAS T A
C H AS Q U I DO DE S U J E C I
2. Firmly push bag dock door with both
thumbs on indication point until
it snaps.
E S C U C H AR U N
Ó N
Tabla de contenido
