Tabla de contenido
q
z
q
e
w
r
t
n
u
e
w
r
y
i
4-Step Buttonhole
Machine setting
q Stitch pattern:
w Stitch length:
e Thread tension: 1 – 5
r Presser foot:
z Set the pattern selector dial at "
Carefully mark buttonhole length on fabric.
Place the fabric under the foot with the buttonhole
marking running toward you.
Draw both of needle and bobbin thread to the left.
Move the slider toward you so that the top mark w
on the slider meets the start arrow q.
q Start arrow
w Top mark
e Needle thread
r Bobbin thread
NOTE:
The scale on the slider is engraved in centimeters.
x Sew forward until you reach the front marking
of your buttonhole. Stop sewing at a left stitch.
c Raise the needle to its highest position.
Set the pattern selector dial at "
then stop sewing at a right stitch.
v Raise the needle to its highest position.
Set the pattern selector dial at "
the needle reach the back marking of the buttonhole.
b Raise the needle to its highest position.
Set the pattern selector dial at "
then stop sewing with the needle above the fabric.
Set the stitch length dial to "0" and the pattern
selector dial at straight sewing (B setting).
Sew a few locking stitches.
n Raise the needle and presser foot. Remove
the fabric from the machine and cut the sewing
thread. Insert a pin inside the bartack.
Then cut the opening with a seam ripper.
Take care not to cut the stitches.
t Pin
y Seam ripper
To adjust buttonhole stitch density:
Set the stitch length dial between "
the buttonhole stitch density.
u Denser buttonhole
i Coarser buttonhole
44
0.5 – 1
Sliding buttonhole J
".
". Sew 5 stitches,
". Sew until
". Sew 5 stitches,
" to adjust
Tabla de contenido
