Tabla de contenido
Idiomas disponibles
Idiomas disponibles
1.5
DESCRIPTION OF THE MACHINE
-
(Picture 1a: bench grinder)
-
(Picture 1b: combined bench grinder)
1.
MACHINE BODY
2.
TURNING-ON SWITCH
3.
ABRASIVE GRINDING WHEEL
4.
TRANSPARENT SPARK ARRESTERS
5.
SAFETY CAP
6.
PIECE-REST
7.
ADJUSTABLE CHIP GUARDS
8.
KEEPER HOLES
9.
BRUSH PROTECTION
10 . SHAFT EXTENSION
1.6
PACKING REMOVAL, STORAGE and
TRANSPORT
Packing removal
If the machine is fit with a base, first separate it
from the machine by removing the fastening screw
nuts.
Remove the machine from the packing that protects
it during transport. Please do not throw the box
away, it could be useful in case you will have to
displace the machine or need to store it for long
periods.
Displacement and transport
WARNING: The machines with more
than 1100 Watt are very heavy and must
therefore be lifted and positioned on
the
choosen
Otherwise they have to be displaced
by at least two people.
Machines with a lower power can be lifted and
displaced by one person only.
Storage
Should you have to store the machine, please take
into account the ideograms printed on the box. Do
not crush the box with overloads and put it in a
safe position so that it does not fall.
working
place.
2
INSTALLATION
Positioning in working area (Picture 2)
CAUTION: Ensure that the machine is
located in a suitable area both as far
as work environment and lighting are
concerned: always keep in mind that
the
overall
conditions are essential for preventing
accidents.
Position the machine on a sufficiently flat bench
so as to have the best stability possible.
The ideal height of the bench is that allowing the
positioning of the piece-rest 6 at about one meter
from the ground.
Machine fastening on working table (Picture
1a)
We recommend to secure the machine to the work
bench, by inserting four M6 screws in holes 8,
locking them on the opposite side using the
appropriate screw nuts.
Machine fastening on the column (where
foreseen)
In order to secure the machine to the base, use
the standard fittings provided. Match holes 8 of
the machine with the corresponding holes in the
upper support surface of the base.
Securing the base to the floor
The column (if delivered with the machine) has to
be fixed to the floor through the special holes on
its lower part. Furthermore fill it with sand to avoid
vibrations and in order to increase its stability.
Fitting of auxiliary equipment
From the bag inside the packaging take out the
adjustable chip guards 7, the transparent spark
arresters 4 and the piece-rests 6 and assemble
them onto the safety caps 5 using the screws
inside the same bag, as shown in picture.
work
environment
9
Tabla de contenido
