SentrySafe SFW123BDC Manual Del Propietário página 7

2
3
Programming a secondary code and fingerprint
(2 fingerprints allowed per person using the safe)
To ADD a secondary code and fingerprint:
Press the "PROG" key.
1
Enter the 5 digit user code.
2
Enter the new 5 digit secondary code
3
The blue light will blink when the system is waiting for a finger swipe.
4
Swipe your finger in the downward direction over the fingertip sensor.
NOTE: If your finger swipe was accepted, a green light will flash and a beep will sound. If your
finger swipe was not accepted, a red light will flash and a low beep tone will sound.
Five to ten accurate reads of the fingerprint are necessary for successful enrollment.
5
Successful enrollment occurs when the green light flashes three times and three
beeps are heard.
If enrollment is unsuccessful, the red light will flash three times and three low beep
6
tones are heard. The system will then shut down and you should repeat steps 1-5.
If you would not like to enroll a finger, wait for the system to timeout or press the
7
"CLEAR" button.
To DELETE a secondary code and fingerprint:
Press the "PROG" key.
1
Enter the 5 digit user code.
2
Press 0,0,0,0,0.
3
NOTE: Deleting a secondary fingerprint will also delete the secondary code.
NOTE: The biometric lock asks for two fingerprints when programming a user fingerprint.
If you would like to only use one, allow for lock to timeout or press the "CLEAR" button.
Swipe your finger in a downward direction over the
fingerprint sensor.
A green light and one beep indicate the
acceptance of a fingerprint.
Rotate the handle downward to open the door.
This may take a limited amount of force because you
have a water resistant safe.
7