INSTALLATION
STEP
1
Determine
the
Header
Bracket
Location
To prevent possible SERIOUSINJURYor DEATH:
• Header bracket MUSTbe RIGIDLY fastenedto structural
support on header wall or ceiling, otherwise garage door
might not reversewhen required. DO NOT install header
bracket over drywall.
• Concreteanchors MUSTbe used if mounting header bracket
or 2x4 into masonry.
• NEVERtry to loosen, move or adjust garage door, springs,
cables, pulleys, brackets, or their hardware, all of which are
under EXTREME tension.
• ALWAYScall a trained door systems technician if garage
door binds, sticks, or is out of balance. An unbalanced
garage door might not reverse when required.
Header Wall
Installation procedures vary according to garage door
types. Follow the instructions which apply to your door.
1. Close the door and mark the inside vertical centerline of
the garage door.
2. Extend the line onto the header wall above the door.
You can fasten the header bracket within 4 feet
(1.22 m) of the left or right of the door center only if
a torsion
spring
or center bearing plate is in the
way; or you can attach it to the ceiling (see page 13)
when clearance
is minimal.
(It may be mounted
on
the wall upside down if necessary,
to gain
approximately
1/2" (1 cm).)
If you need to install the header bracket on a 2x4
(on wall or ceiling), use lag screws (not provided)
to securely fasten the 2x4 to structural supports as
shown here and on page 13.
3. Open your door to the highest point of travel as shown.
Draw an intersecting horizontal line on the header wall
above the high point:
• 2" (5 cm) above the high point for sectional door and
one-piece door with track.
• 8" (20 cm) above the high point for one-piece door
without track.
This height will provide travel clearance for the top edge
of the door.
NOTE: If the total number of inches exceeds the height
available in your garage, use the maximum height
possible, or refer to page 13 for ceiling installation.
Header Wall
_2"
(5 cm)
Track
Highest Point
of Travel
--Door
Sectional
door with curved track
Header Wall
: 8" (20 cm)
i
.........
]
Door
_
Highest
Point
_
of Travel
One-piece
door without track:
jamb hardware
Y
IT
One-piece
door with horizontal
track
Header Wall
Track
_nt
7
of Travel
I
Highest
,, Point
'1 of Travel
,i
Doe
,i
One-piece
door without track:
pivot hardware
12