Planning; Sectional Door Installations - Craftsman 139.53925DS Manual Del Propietário

Planning
Identify the type and height of your garage door. Survey
your garage area to see if any of the conditions below
apply to your installation Additional materials may be
required You may find it helpful to refer back to this page
and the accompanying illustrations as you proceed with
the installation of your opener
Depending on your requirements, there are several
installation steps which may call for materials or hardware
not included in the carton
o Installation Step 1 - Look at the wal! or ceiling above
the garage door. The header bracket must be securely
fastened to structural supports
o installation Step 4 - Depending upon garage
construction, extension brackets or wood blocks may be
needed to install sensors
° Installation Step 4 - Alternate floor mounting of the
safety reversing sensor will require hardware not
provided
* Installation Step 6 - Do you have a finished ceiling in
your garage? If so, a support bracket and additional
fastening hardware may be required
Do you have an access door in addition to the garage
door? If not, Model 53702 Emergency Key Release is
required See Accessories page
Look at the garage door where it meets the floor Any
gap between the floor and the bottom of the door must
not exceed 1/4" (6 ram). Otherwise, the safety reversal
system may not work properly See Adjustment Step 3
Floor or door should be repaired_
SECTIONAL DOOR INSTALLATIONS
° Do you have a steel, aluminum, fiberglass or glass
panel door? if so, horizontal and vertical reinforcement
is required (Installation Step 12).
• The opener should be installed above the center of the
door. If there is a torsion spring or center bearing plate
in the way of the header bracket, it may be installed
within 4 feet (12 m) to the left or right of the door
center See Installation Steps 1 and 12
• If your door is more than 7 feet (2.13 m) high, see rail
extension kits listed on Accessories page.
SECTIONAL DOOR INSTALLATION
Horizontal and vertical reinforcement
is needed for $_ghtweight garage doo_s
(fiberglass, steel, aluminum, door with
glass panels, etc.) See page 23 for details
Header Wall
Rat!
Torsion OR
Spdng
FINISHED CElUNG
Supped bracket &
faslening hardware
is required.
See page 19
Extension
Spring
Motor unit
Waif
Door
Control
_Sa_ety Reversing Sensor
Safety Reversfng
Gap between floor Sensor
and bottom of door
must not exceed I/4" (6 ram)
AccessDoor
O
CLOSED POSITION
Header
_ackel_RailB_:aGke,
Doo_ I I
O,noio/ --
Straighl /_/
°2r4 /
_Curved
_i Ooer ?oor
Brackel Arm
Flail Assembly
:";!". ........
_Trolley
Emergency
Retease
Rope & Handle