Mounting And Wiring The Safety Reversing Sensors - Craftsman 139.53925DS Manual Del Propietário

MOUNTING AND WIRING THE SAFETY REVERSING
SENSORS
• Slide a 1/4"-20xl/2" carriage bolt head into the slot on
each sensor.. Use wing nuts to fasten sensors to
brackets, with lenses pointing toward each other across
the door.. Be sure the lens is not obstructed by a bracket
extension (Figure 5)..
° Finger tighten the wing nut&
Recommended Wire Routing
1..Using insulatedstaples, run the wires from both sensors
to the rail at the door header (Figure 6).
2 Run the wires through wire cIip at the top of the rails.
NOTE: if.your access door is near the garage door, you
may choose to install the door control at this time and
run the door control wire along the raft with the sensor
wires.. If you choose this option, follow instructions 1-3
on page 20°
Figure 5
Wing Nut
Cai'riage Bolt
lI4"-20xt/2"
HARDWAR_ SHOWN ACTUAL SIZE
Wing Nut Slapl_s
1/4"-20
Wire Clip
Figure 6
Be1)Wire
..--'" I
.J/ !
-{ i
Safe I
Sensor I _'_'N ....
Invisible Ughl Beam
Protection Area
Safely Reve/sincj
Sensor
17