Assembly - Remington RM2570 Manual Del Operador

INSTALLING THE CUTTING HEAD SHIELD
WARNING:
To prevent serious personal injury, never
operate the unit without the cutting head shield in place.
1. Remove the wing nut and washer from the cutting head shield.
2. Insert the short tab (the one without a hole) on the mount
bracket into the slot on the cutting head shield (Fig. 1).
3. Rotate the cutting head shield until the bolt on the cutting head
shield protrudes through the hole on the mount bracket (Fig. 1).
4. Place the washer onto the bolt (Fig. 2).
5. Screw the wing nut onto the bolt until the cutting head shield is
firmly in place (Fig. 2).
INSTALLING AND ADJUSTING THE HANDLE
Installing the Handle
1. Push the handle down onto the shaft housing (Fig. 3). The bolt
hole in the handle should be to the right.
2. Insert the bolt into the bolt hole and push it through (Fig. 3).
Tighten the bolt with a 3/ 8" socket, but do not tighten the bolt
completely .
3. While holding the unit in the operating position (Fig. 10), move
the handle to the location that provides the best grip. Place it a
minimum of 6 inches (15.24 cm) from the end of the shaft grip
(Fig. 3).
4. Tighten the bolt with a 3/ 8" socket until the handle is secure.
Adjusting the Handle
If the handle requires adjustment:
1. Loosen the bolt with a 3/ 8" socket (Fig. 3).
2. While holding the unit in the operating position (Fig. 10), move
the handle to the location that provides the best grip. Place it a
minimum of 6 inches (15.24 cm) from the end of the shaft grip
(Fig. 3).
3. Tighten the bolt with a 3/ 8" socket until the handle is secure.

ASSEMBLY

Bolt
Cutting Head
Shield
Bolt
Shaft Grip
Minimum 6 in.
(15.24 cm)
Bolt
6
Hole
Fig. 1
Fig. 2
Fig. 3
Mount Bracket
Tab
Slot
Wing Nut
Washer
Handle
Shaft
Housing