NuTone HEAT-A-VENTLITE 9093WH Manual De Usuario página 2

INSTALLATION
WARNING: To reduce the risk of fire, do not store or use
gasoline or other flammable vapors and liquids in the vicin-
ity of the heater.
CAUTION: High temperature, risk of fire, keep electrical
cords, drapery, furnishings, and other combustibles at least
3 feet (0.9 m) from the front of the heater and away from the
side and rear.
1. Remove complete assembly from carton. Loosen screws
holding grille and remove the grille.
2. Loosen power unit mounting screws and remove power unit
from rough-in housing.
3. Remove tape from back draft damper and be certain the
damper opens and closes freely.
MOUNTING TO OPEN JOISTS
Refer to Figure 1.
1. Insert hanger bar on mounting bracket opposite discharge
opening and mount rough-in housing to ceiling joists at
desired location.
2. Install mounting brackets into slots in housing and adjust
housing so flange will be flush to proposed finished ceiling
line. Tighten screws securely.
3. Attach 4" round duct and vent to outside through wall
or ceiling.
4. Remove junction box cover and desired knockout from
junction box in housing.
ADJUSTABLE
HANGER
BAR
HEATER
OUTLET BOX
NAILING BRACKET
NAILING BRACKET
FIGURE 1
MODEL 9093WH
Page 2