Tabla de contenido
Idiomas disponibles

Idiomas disponibles

®

Locker Leveling

Access Locker Leveling Glides
1.
Open door, Remove packaged shelves if supplied.
2.
Using tape attached to the bottom, lift tape on
bottom pan to pull up for access to leveling
glides. If there is not tape already
attached, use masking tape.
- For Cubby Lockers remove the
lowest door to prevent scratching
and damage. To remove the door
release the latch by detaching hinge.
3.
Level the unit. Access to glides is
from inside the locker after
removing the bottom pan.
4.
Multipurpose Locker comes with
adjustable Shelves. Remove from
packaging and install shelf clips.
BOTTOM PAN
2
Level The Unit
Leveling of the cabinet is critical to ensure proper
function of the unit as well as maintaining and
protecting its aesthetics.
Adjust leveling glides while checking with level
both front-to-back and side-to-side.
Insert Shelf Clip and Install Shelf
To insert, angle down so top of clip goes in first.
Then squeeze and place into notch just below.
Make sure all four (4) clips are at same number of
notches high to ensure a level shelf.
Place back of shelf on notches first, then the front.
Page 15 of 57
P/N 939504734
Doc # 70305 Rev J
Tabla de contenido
loading

Tabla de contenido