Tabla de contenido
Idiomas disponibles
Idiomas disponibles
6. Maintenance
Assuming that the PlasmaMade Airfilter has been installed according to the instructions,
it requires little maintenance. The PlasmaMade Airfilter is cleaned automatically as soon
as it is put into operation.
If the outside or the sensor becomes dirty with for example dust deposits, these may be
cleaned off simply using a vacuum cleaner.
There are no components that need to be replaced periodically.
You must follow the maintenance instructions of your extractor hood.
The grease filters must be of a good quality, always cleaned regularly and in order to
prevent contamination of the PlasmaMade filter.
7. Faults
Incompetent repairs are dangerous – you run the risk of an electric
shock! If the device is faulty, remove the plug from the socket and contact
customer service.
Fault
Device does not
The plug is not inserted
work
in the socket
Power cut
Blown fuse
Red lamp flashing Overloading of filter.
Blue light slashes The cleaning time of the Turn the hood off. You can re-enable the
during the
filter is reached
operating mode
Blue lamp
The maximum lifetime of Purchase a new filter
flashing
the filter is reached
If the error is not resolved after these operations, please refer to our Helpdesk at:
www.plasmamadeservice.com
9
Possible cause Solution
Put the plug into the wall socket
Check whether other kitchen equipment is
working
Check in the meter cupboard whether the
device's fuse is intact
Remove power from the filter temporarily
(remove the plug from the socket briefly) –
thereafter the electronics will reset itself
hood after 1-2 minutes
Capítulos
Tabla de contenido
