Phonebook; Telephone Numbers; Options; Dial Options - DSC GS3100 Manual Del Usario

Phonebook

The Telephone Page phonebook holds 100 telephone numbers.

Telephone Numbers

† Description: enter an alphanumeric string of up to 16 characters.
† Telephone number: enter a telephone number of up to 16 digits, preceded by the correct international prefix in the format
"+xxx" (only digits and "+" signs are accepted).
† Activates Output: select the telephone numbers which should activate Output OC3 (T3) when the Communicator receives
a call from these. This function does not depend on the White List or Black List options (Options page->Dial options).
† White List: enable ; ; ; ; ; or disable … … … … … the White List area would allow the Communicator to accept or refuse incoming
calls. The functioning mode of the White List option is linked to the ; ; ; ; ; selection or non-selection … … … … … of the Black List,
area which is present on the inside of the Options page->Dial options, as seen in the following table:
:KLWH /LVW
…
…
;

Options

This page is used to set the options relating to the board.

Dial options

This part is used to enter some of the characteristics relating to the telephone numbers used.
† Prefix: this Device will prefix the digits entered in this field to all the telephone numbers dialled through the GSM Interface
function. If necessary enter a Prefix (maximum 8 digits) in this field. If no Prefix is required, leave this field empty.
† Digits to Remove: If this Communicator is connected downstream to a switchboard, the telephone numbers (programmed
on the Control panel) must be preceded by the switchboard number (normally one digit). As the switchboard number is
not required when calls are sent over the GSM Network, it must be removed from the digits which form the telephone
number. Enter the number of digits that form the switchboard number (e.g. if switchboard number is 01, enter 2 in the
"Digits to remove" field, as 2 numbers form the switchboard number).
, , , , , The telephone number should at least have two digits more that the number in the "Digits to remove" area,
otherwise the engaged tone will be come through, e.g.:
— the dialled telephone number is 0123, with 2 digits to be removed = correct, the remaining number to be
inserted is 23.
— the dialled telephone number is 123, with 2 digits to be removed = engaged tone, the remaining number
to be inserted is 3.
† Enable Black List: Check this box if you do not wish to receive calls from stored telephone numbers, authorising only
the numbers selected previously using the White List function (Options page->Dial options).
GS3100
%ODFN /LVW
…
$FFHSW LQFRPLQJ FDOOV IURP DQ\ QXPEHU
; 5HIXVH DQ\ LQFRPLQJ FDOO
$FFHSW LQFRPLQJ FDOOV RQO\ IURP QXPEHUV KDYLQJ DQ HQDEOHG
;
:KLWH /LVW RSWLRQ UHIXVH FDOO FRPLQJ IURP DOO RWKHU QXPEHUV
)XQFWLRQLQJ PRGH
G G G
G G
13