EB TECHNOLOGY TRANSCEIVER-TXMINI Instrucción página 13

TRANSCEIVER v2
Memorization of TX and RX
Before starting the memorization, put dip-switch 4 of the tx as shown:
DIP 4 - TX
ON
OFF
Memorization IN 1
1 2 3 4
How to learn a code on OUT 1 (RX)
To associate one safety edge to the output OUT1 in the receiver do as follow:
1. Press once the P1-PROG of the receiver, LED-TX1 flashes once.
2. Press P1 of the transmitter within 60 seconds after pressing P1-PROG.
3. If the buzzer sounds it means that the operation is confirmed, if the TX is already memorized the buzzer
beeps three times.
4. Once the memorization has been completed, the receiver works automatically and the LED-RX1 turns off.
If you need to memorize extra transmitters start from point 1 again.
How to learn a code on OUT 2 (RX)
To associate one safety edge to the output OUT2 in the receiver do as follow:
1. Press twice the P1-PROG of the receiver, LED-TX1 flashes once.
2. Press P1 of the transmitter within 60 seconds after pressing P1-PROG.
3. If the buzzer beeps it means that the operation is confirmed, if the TX is already memorized the buzzer beeps
three times.
4. Once the memorization has been completed, the receiver works automatically and the LED-RX1 turns off.
If you need to memorize extra transmitters starts from point 1 again.
P1
LED
P2
TX1
IN. 1
NC
ON
1 2 3 4
-13-
Technical manual
DIP 4 - TX
ON
Memorization IN 2
P1
LED
P2
TX1
IN. 2
NC