Tv And Audio/Video Settings; Setup Of Wii Remote; Installing Batteries - Nintendo Wii Manual De Operaciones

Ocultar thumbs Ver también para Wii:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

S y s t e m S e t u p

TV and Audio/Video Settings

After you have completed all steps of the setup procedure and are ready to
use the Wii system, you will need to set the appropriate "input select"
setting for your TV, VCR or other audio equipment.
1. Turn ON the power for your TV and any audio equipment connected to your
gameplay setup and the power on the Wii console.
2. Select the correct input setting for your TV (see Input Select Infomation below).
3. The Wii Menu should appear on the TV screen. See the Channel section of the
Operations Manual for more information on this feature.
If the Wii Menu screen does not appear, check to make sure your input setting is
correct and review the Troubleshooting section on pages 31-32.
Input Select Information
The input select allows you to switch between the different inputs on your TV or VCR.
Manufacturers of TVs and VCRs use different names and locations for "input select".
The common names for the input select are: input, select, input select, line, line in,
source, in, EXT, and AUX. Consult your TV or VCR instruction manual for details.
NOTE: More information on "Input Select" is available on our web site at
www.nintendo.com/consumer/inputselects.html
Locate the input select for the component that the Wii AV Cable is connected to (either
the TV or VCR). The most common locations for input select are:
•A button on the front of the TV or VCR.
•A button on the remote control.
•A high-numbered or low numbered channel (92, 99, 00, or 02) on the TV or VCR.
•An on-screen menu selection.
18
Setup of the Wii Remote
The remote uses AA batteries. Use only high quality alkaline batteries for best
performance and longevity of battery life.
WARNING - Battery Leakage
Leakage of battery acid can cause personal injury as well as damage to your remote.
If battery leakage occurs, thoroughly wash the affected skin and clothes. Keep battery
acid away from your eyes and mouth. Leaking batteries may make popping sounds.
To avoid battery leakage:
• Do not mix used and new batteries (replace all batteries at the same time).
• Do not mix different brands of batteries.
• Use only alkaline batteries. Do not use lithium ion, nickel cadmium (nicad),
nickel metal hydride (nimh), carbon zinc or any other non-alkaline batteries.
• Do not leave batteries in the remote for long periods of non-use.
• Do not recharge the batteries.
• Do not put the batteries in backwards. Make sure that the positive (+) and
negative (-) ends are facing in the correct directions. Insert the negative end first.
When removing batteries, remove the positive end first.
• Do not dispose of batteries in a fire.

Installing Batteries

1. Remove the battery cover on the back of the Wii Remote and insert two AA batteries
as shown.
2. Be sure to insert the minus (–) end first when inserting new batteries, and remove
the plus (+) end first when replacing the batteries.
3. Replace the battery cover.
Wearing the Wii Remote Wrist Strap
CAUTION - Use the Wrist Strap
Wii gameplay with the Wii Remote can involve rapid or vigorous motion.
Please use the wrist strap to prevent losing your grip on the remote and causing
damage to the remote or surrounding objects, or injury to other people.
1. Place your hand through the wrist strap and hold the remote firmly in your hand.
2. Slide the strap lock up so that the strap will not fall off your wrist. Do not over
tighten the strap lock so that it's uncomfortable. It should just be tight enough to
hold the wrist strap in place.
19
Tabla de contenido
loading

Tabla de contenido