Internal Cleaning Instructions; Cleaning Instructions For K03-Ts / K04-Ts; Acement Sound-Absorbing Panels K03-Ts - FPZ SCL K03 Manual De Instrucciones

Ocultar thumbs Ver también para SCL K03:
Idiomas disponibles
  • ES

Idiomas disponibles

3.

INTERNAL CLEANING INSTRUCTIONS

CAUTION!
Internal deposit build up can cause:
performance variations;
alteration in clearances resulting in seizing;
out of balance rotor.
3.1

CLEANING INSTRUCTIONS FOR K03-TS / K04-TS

In case it is necessary to clean the inside of the blower, proceed
as follows:
1.
Remove #183 foot through the extraction of #920 4 x
screws.
2.
Remove in order #915 and #902.2 screws placed on #162
cover.
3.
Remove #162 cover by using the two holes between #103
intermediate housing and #162 cover.
4.
Remove the #900 screw and #365 washer.
5.
Remove the #360 bearing cover and extract the #321
bearing using a bearing puller.
6.
Remove the #231 impeller if necessary using a puller and
remove the #940 key.
7.
Remove the #902.1 screws on the #104 intermediate cover.
8.
Remove the #103 and #104 and place them together, by
using the two holes between #104 intermediate cover and
#161 housing.
Cover extraction's hole
162
231
902.2
103
902.1
934
360
915
321
365
900
940
423
920
GB - 17/48
9.
Remove the #934 spacer.
10. Remove the #935 shims-be careful not to misplace.
11. Remove the #230 impeller if necessary using a puller and
remove the #940 key.
12. Clean and reassemble in reverse order.
If needed, reconstruct #423 seal using Loctite 598 or similar,
after cleaning the sealing surfaces of any existing sealant.
It's important not to reverse the position of the #230 and
#231 impellers.
3.1.1
REPLACEMENT SOUND-ABSORBING PANELS FOR
K03-TS / K04-TS
If needed, replace the foam sound-absorbing panels, proceed as
follows:
1. Remove #906 screws.
2. Take away the #700 silencers from the unit, being careful
not to lose the #422 gaskets.
3. Extract the #720 panels from the silencer housings.
4. Clean up the #710 retaining screen.
5. Replace and reassemble proceeding in reverse order,
remembering to include the #424 gaskets.
104
161
230
935
183
424
906
700
710
720
loading

Este manual también es adecuado para:

Scl k04Scl k05Scl k06