Dab Mode - auna multimedia V-14 DAB Manual Del Usuario

Tune to an FM station preset
In FM mode:
1. Repeatedly short press the Prog. button on the front of the Micro or on
the remote control to move through the 1-10 preset locatons.
2. Use the buttons on the Micro or the
/
control to move the preset location and station that you would like to
listen to (1-20).
3. Short press the Select button. Your Micro will tune to that station and
begin to play.
Note: If no FM station has been stored under the preset location, 'Empty'
will be displayed, then the Micro will revert to the previously selected
radio station.

DAB MODE

• If you are not already in DAB mode, short press the Mode button on the
front of the Micro or on the remote control to go to DAB mode (check
the display).
• If you were listening to an DAB station when you switched the Micro
off then this station will be automatically selected when you switch the
Micro back on.
Wire radio aerial
• Please make sure that the wire aerial on the back of the Micro is fully
extended and adjusted before you attempt to tune to an DAB radio
station (a vertical position is recommended).
• This will ensure that the maximum signal strength is available when
the Micro begins to scan. Extending the aerial also ensures the best
possible sound quality.
Changing DAB stations
1. Use the buttons on the Micro or the
/
control to scroll through the available stations.
2. When the station that you would like to listen to is displayed, short
press the Select button on the Micro or on the remote control. There
will be a short delay whilst your Micro tunes to your selected station.
buttons on the remote
/
buttons on the remote
/
EN
47